Votes
Answers
Views
Question
0
1
142
asked 7 years ago by coleslaw
updated 7 years ago by jameslcoleman
We are in need of a test status analysis report for the number of test steps in ALM with a passed or failed status. We have multiple folders levels in the Test Lab, and we need to report on a given folder level and all of the sub-folders/test sets from that folder in Test Lab.
0
1
65
asked 7 years ago by buffalo-bill
updated 7 years ago by pt-barnum
Is there a way to setup the Renumber Steps in test plan steps to a sequence as "Step 001", "Step 002"... instead of "Step 1", "Step 2"...?
7
1
43
asked 14 years ago by derlweldon
updated 14 years ago by sammyh
Users are receiving a "Cannot display Test" error while attempting to view QTP test steps copied from another project. This error did not occur on the QCv9.2 instance. This error is occuring on a project we ported and upgraded to QCv10. Any Ideas??
1
1
43
We exported test cases from Excel into Quality Center using the Excel Add-in. When we did, the format used for the test step number imported as just a number into QC instead of "Step 1". Now when users manually add a step they are not able to renumber the steps. Is there an easy way to chang...
0
1
27
I was wondering if you can change the order of the Test IDs when a Tests with Design Steps Report is created. Currently it goes from the highest Test ID to lowest. I want it to go from lowest to high. I know that you can do the following to do it : Analysis View > Analysis Menus > Test Plan Analysis...
8
1
26
asked 10 years ago by tlstockton
updated 10 years ago by sammyh
We have the problem that the run test steps in a project reports have the wrong order. Instead of starting with test step 1 and ending with test step n (where n list is the last test step) the report starts with test step n and ends with test step 1.
1
1
24
asked 10 years ago by pinkyboo27
updated 10 years ago by Dan
Hi, when you edit a step or paste in a step into a test in ALM 11 it will automatically scroll back up to the first step in the test after you click away from the step you were editing/pasting. I was wondering if there is a setting or something in ALM 11 where you could stop it from doing this? I fe...
2
1
23
asked 7 years ago by ditch-brodie
updated 7 years ago by mrwhite
I would like to add a report that could pull results for tests in test plan that have either zero or 1 step only in them. Not sure of best method to attempt this as the regular project reports don't seem to have any filter option for such a thing.
7
3
18
asked 13 years ago by fuzzy-davis
updated 12 years ago by dinesh
Need an Excel Report that includes Path and Steps