Votes
Answers
Views
Question
2
votes
1
answer
515
views
Run Results are not accessible through HP QC/ALM when using HP UFT 12.50. The results display, but have an error when you select to view Run Results. I am using QC 12.20.
0
votes
1
answer
379
views
asked 8 years ago by hank-the-hammer
updated 8 years ago by bubblehead712
I am testing REST services using UFT 11.50. After sending the request, HP test results viewer shows captured data. In it, 3 properties - RequestBody, HttpRawRequest and ResponseBody - are shown as links. Is there a way to show them as text in the run results viewer? Content type is set to applicatio...
0
votes
1
answer
188
views
asked 10 years ago by khweziluzipho
updated 10 years ago by garystew
I'm unable to collate my results on PC11.52. I runs all the tests successful then collating results takes very long time to finish or takes forever. Please advise
0
votes
1
answer
185
views
asked 8 years ago by coleslaw
updated 8 years ago by jameslcoleman
I want to install the test results viewer plug in on a pc with no UFT installed, but a tester that uses the results viewer and UFT said there were a couple of patches needed for the UFT results viewer. If I install the plug in, will I also have to install patches? If so which patches?
10
votes
2
answers
104
views
asked 12 years ago by hank-the-hammer
updated 12 years ago by Michaeldx
Just ran QTP test with no problem and the HP run results viewer displays "Can't create data table". Does anybody know what is wrong
9
votes
1
answer
71
views
asked 12 years ago by neena
updated 12 years ago by bubblehead712
The Run Results Viewer for QTP 11 is failing to load the data file after an error has occurred in trying to render the results. Clicking on the Data Table Tab causes the Viewer to crash with a fatal error. RRV_00019.EXE has been applied.
0
votes
1
answer
54
views
asked 9 years ago by godawgs
updated 9 years ago by David Hall
Whenever I try to Launch a Report through the Launch button in QC for Test Results I get an error message indicating that an "Object reference not set to an instance of an object" so I can not view the test results with the RunResultsViewer. I've tried re-running the Install in Repair mode t...
2
votes
1
answer
48
views
When running a test from ALM and a Reporter.ReportEvent statement executes, I'm unable to view the resulting output in the Run Results viewer. I have tried running a repair on UFT but it did not work.
2
votes
1
answer
44
views
I have the run results viewer set to capture a video at every run. I manually set this in the Options and it has always worked. Suddenly, it stopped working despite all the settings being set exactly the same. It says no output associated with this view. This is a very vital part of my testing to ac...