Access is Denied message when running remote

  • Questions
  • Access is Denied message when running remote
Question ID: 107953
1
0

When running UFT scripts on remote machine through Quality Center I am getting "Access is Denied" message, what could be causing this error?

Marked as spam
Posted by (Questions: 92, Answers: 3)
Asked on October 27, 2017 2:07 pm
35 views
Answers (1)
1
Private answer

The ''Access is Denied'' message is usually caused because of DCOM permissions on the UFT machine that the script is trying to run on. Here are a few things that I would like to have you try:

On the UFT remote machine that you are trying to send the run TO, run the ''Additional Installation Requirements'' wizard for UFT, this can be found in the start menu under HP UFT or by searching the machine for ''Additional Installation Requirements'' then run the wizard (make sure that you select both ''Configure DCOM settings for ALM Integration'' and ''Configure DCOM settings for Automation Scrpts'') then click Run. Close the wizard then try running to the test again.

Marked as spam
Posted by (Questions: 0, Answers: 340)
Answered on October 27, 2017 2:08 pm