Receiving a Closure Fuse Exceeded error when trying to check out a test.

  • Questions
  • Receiving a Closure Fuse Exceeded error when trying to check out a test.
Question ID: 108379
0
0

Hello. We are using a version control enabled project, and we have users receiving a 'Closure Fuse Exceeded' error when trying to check out a test case. I was also able to reproduce the error when I tried checking out the same test case. Can you assist us with this issue?

Marked as spam
Posted by (Questions: 217, Answers: 21)
Asked on May 4, 2018 1:13 pm
36 views
Answers (1)
0
Private answer

Hello. I would like for you to try adding the parameter CLOSURE_ROWS_FUSE_FACTOR_PCT into the 'Site Configuration' tab within Site Admin. This parameter is used to adjust the limitation on the number of rows of each table allowed in a closure for all features (such as baseline, version control, copy/paste). By default, the value for this parameter is 100, which means 100% of the original limitation defined on the number of rows for each entity. I would like for you to set the value of this parameter to 300000, which will increase the default limitation 3000 times. You may need to restart the ALM service after you adjust the parameter value, for the change to take affect.

Marked as spam
Posted by (Questions: 217, Answers: 21)
Answered on May 4, 2018 1:14 pm
Adding the parameter you suggested resolved the issue. We are now able to check out the test. Thank you for your assistance!
( at May 4, 2018 1:15 pm)