Retaining Current IP Spoofing IP Addresses

Tags:

Question ID: 104528

We are in process of upgrading Loadrunner from v9.52 to v11.04 , We have two LoadRunner agents on which we have IP spoofing range specified , how can we retain or set it up again once we install v11.0?

Marked as spam

Posted by Iama_mess (Questions: 231, Answers: 18)

Asked on June 1, 2012 10:48 am

46 views

Answers (1)

▲

▼

✔

Private answer

When you added the IP Addresses, they will be stored in a .bat file. The name of this file
Is ''nt_routing.bat''. Please follow the following steps

1. Locate the nt_routing.bat ----> example C:tempnt_routing.bat
2. Copy the nt_routing.bat file
3. After LoadRunner installed and updated, Launch the IP Wizard and Load the nt_routing.bat file.

VERIFY IP ADDRESSES ADDED
4. Start Menu -> Run -> CMD -> enter ipconfig. All available IP addresses should be displayed
Settings in the Controller:
* RUN-TIME SETTING-RUN AS ''PROCESS'' (IN GENERAL TAB)
* IN THE CONTROLLER TOOLBAR ''SCENARIOS'' TAB, ENABLE IP SPOOFER
* IN THE CONTROLLER TOOLBAR ''TOOLS'' TAB, CHECK ''EXPERT MODE''

Setting in ''Network Neighborhood'' (On the Load Generator Machine). Also, verify that all of the new IP addresses are on the list in ''Network Neighborhood''/''Properties''/Protocol/Advanced.

Verify that Wins address and DNS are completed with the correct IP addresses.

Marked as spam