Votes
Answers
Views
Question
0
votes
1
answer
217
views
asked 6 years ago by bhogapuram
updated 6 years ago by raja
I want to display only certain steps in the Test Run Results reports even i use report event in all my steps.
0
votes
2
answers
167
views
asked 11 years ago by sean-phillips
updated 11 years ago by Michaeldx
I want to use UFT to read and store the test results of another test that is in the same test set in ALM. I'm thinking that this would be done using QCUtil, but I'm not sure where to go from there. Any help would be great!